See Table A for pipe lengths. Fundamentals of Gas Appliance Venting and Ventilation, 1985, American Gas Association Laboratories, Engineering Services Department. C Either System preferred manner : Turn off the main power to burner and remove the control unit. Be sure they are facing up. Should lock-out occur, wait at least 20 seconds, then re-set primary control. Tighten the 4 screws, 6, securely.
It is recommended that only the burner be connected to the chimney. Tel: 416 964-9415 1-800-268-7070 Email:. It must be remembered that the fan capacity with this plate in place, is greatly altered and should not be used at the burner's higher firing rates. B Remove the drawer assembly, 1, from inside the blast tube by undoing the screw, 2. Suction and return lines should be the same size and both should extend to the same depth inside the fuel tank.
B Remove the air tube cover plate. Riello has always believed and invested in the search for new materials and in the development of more advanced combustion technology and is able to offer products which respect the strictest environmental regulations as well as facing the prospects offered by new alternative fuels. Make proper adjustments for optimum efficiency. Graham, 1947 edition obsolete, out of print. Choose the proper blast tube length for the installation.
The filter should be replaced at least once a 'year and the filter container should be thoroughly cleaned prior to installing a new filter cartridge. Riello has always believed and invested in the search for new materials and in the development of more advanced combustion technology and is able to offer products which respect the strictest environmental regulations as well as facing the prospects offered by new alternative fuels. Special Offer: For a 10% discount on any number of copies of the Home Reference Book purchased as a single order. Once the burner is purged, turn off all power to the burner, remove the jumper cable and replace the control unit. Carson Dunlop Associates' provides extensive home inspection education and report writing material. It might be necessary to create a window to permit sufficient air to enter the boiler!. Excellent tips on spotting problems on oil-fired heating equipment.
The burner will operate with a slight draft or pressure in the chamber. Fill automatic operation with packaged tipe. Make proper adjustments for optimum efficiency. Return power to the burner. The GeniSys is used with a suitable cad cell flame sensor to control the oil burner motor, igniter, and optional solenoid valve.
Burner comes with a boiler or furnace , follow the installation and set-up instructions supplied with the heating appliance, as settings will differ from those shown in this manual. All of our products are backed by unparalleled application experience and comprehensive technical support and training for specifiers and installers. Burkhardt, McGraw Hill Book Company, New York 3rd Ed 1969. Shines a light source on the photocell now visible where the air tube cover was removed , return power to the burner and activate the burner. Tel: 416 964-9415 1-800-268-7070 Email:. Secure the burner using the two bolts 6 supplied. Industry, Fraser-Johnston, Heat Controller, Hydrotherm Inc.
Mark the center of the two holes, 3. Repeat this operation until the pump is primed. Using the setting taken from Table B, column 5, position the air shutter so that the top of the shutter is aligned with the proper index line indicated on the air intake. A tar get wall at the far end of the combustion chamber is useful, but not necessary. Electrical Connections: All electrical connections should be done in accordance with the C. Smith, State Industries, Tekton Corp.
B Secure the 2 halves of the mounting flange, l, to the blast tube using the two bolts, 5. Return the power to the burner. Mark the center of the two holes, 3. Attach the required piping to these two pipe connectors. Mark the center of the two holes, 3. . In this index you will find links to the manual for your oil burner used on heating equipment.